Where to Set Cut Off Voltage Nimh Rc Battery

IMPORTANT!!! READ MANUAL in its entirety in front use. Convey extra precautions when handling Lithium Polymer (LiPo) batteries, as they necessitate different refuge measures compared to NiMH or NiCd batteries! Failure to follow these instructions keister result in severe permanent terms to bombardment, cause serious subjective trauma, OR lead to a sack.

LiPO batteries are intended to constitute used with compatible radio controlled (R/C) models and airsoft guns only. Whatsoever damage caused aside misuse or modifications will void your warranty and can cause serious injury.

By purchasing this ware the vendee/user agrees that they cause read and understood the safety precautions printed in this document and accepts full responsibilities of these risks. Away agreeing, the user/buyer does not hold Tenergy, its distributors, operating theatre its retailers responsible for any accidents, injury to persons, or property damage that May pass off.

If buyer/user does not agree with these conditions, delight bring back the stamp battery in its original condition immediately to the place of purchase.

Gross Safety Guidelines

1. Ne'er use a NiCd/NiMH charger to charge LiPo batteries. Only use chargers intentional for Lithium Polymer (LiPo) batteries.

2. NEVER store LiPo batteries in whatsoever location that exceeds 40-80° F (e.g. in a car, garage, or in the sun)

3. Ne'er will charging batteries unattended. Keep watch on the charging process & react to some potency problems that may occur.

4. NEVER let the battery's positive and negative leads to touch. This can cause the electric battery to truncate and lead to a FIRE. If for any grounds you need to cut the terminal wires, it leave be necessary to cut each electrify SEPARATELY, to make in for the wires do Non meet each other.

5. ALWAYS charge batteries in a fireproof container and away from combustible material. Do NOT charge connected surfaces that pot catch fire – this includes: wood, cloth, carpet, operating room in the application's device.

6. ALWAYS inspect the battery to make sure in that location are no signs of damage, deformity, or swelling before charging. If there are, Discontinue charging the electric battery and follow the proper procedure to dispose of the battery.

7. NEVER shoot a egotistical Oregon ballooned operating theatre flyblown battery (even if swollen upon purchase). Continued to institutionalize A battery that has begun to swell will result in a fire.

   Follow these steps if battery is swollen, ballooned or damaged:
   - Block up the charging process and disconnect battery immediately
   - Gulf shelling from the twist immediately.
   - Come proper procedure to dispose of battery

8. ALWAYS store LiPo batteries in cool, dry places 'tween 40-80° F.

9. If the battery reaches malodourous temperatures in the case of an R/C Model crash, follow these steps:

   - Disconnect battery immediately from the device
   - Watch it for approx 30 minutes from a safe distance.
   - Follow proper procedure to dispose of battery

10. Keep Li-Po batteries unreached of children Beaver State pets.

Avoid Finished-Discharging LiPo Batteries

Ended-discharging—continuing to use a LiPO battery even when information technology is almost completely empty operating theater to a lower place its minimum voltage level—terminate case permanent hurt to the battery.

The legal injury caused by this can be Inside battery impairment and will not always be visible. However, internal damage force out eventually lead to a FIRE when attempting to re-turn on it at later times.

*Precaution: this problem can comprise easily and commonly overlooked in Airsoft applications because there are no indicators that the battery is at a low potential and should Be removed to Be re-charged. Please exercise proper understanding and usage of the battery in your application to forestall safety issues or injuries and to prolong battery life.

Part #52023

Tenergy recommends using a low voltage detecting device for LiPo batteries in Airsoft guns. An example is the Tenergy LiPo Alarm (PN#52023). This LiPo alarm is a great preventive touchstone for maintenance and longevity of LiPo battery packs.

Charging Batteries

Caution – Before Charging

1. Forever visually inspect LiPo bombardment for any damaged leads, connectors, shrink wrap, swelling of cells, Beaver State else irregularities before charging or using.
2. Do NOT use up if you find out any of the above issues with your pack.
3. Before installing or changing the connector, check the voltage of the tamp using a extremity voltmeter (non your courser).
   All new packs ship at approximately 3.80V per cells.
• Examples:
• 2S pack should read approximately 7.60V
• 3S pack should read approximately 11.40V
4. Do non endeavour to charge any clique if staring voltage per cell is to a lesser degree 3.3V
• Examples
• Do not charge a 2-cell clique if below 6.6V
• Do not charge a 3 cell pack if below 9.9V

If any damage to the pack or leads is establish, or if the voltage is significantly less for your pack than specified in a higher place, serve NOT attempt to charge OR use the pack. Contact Tenergy directly as soon American Samoa possible.

Tenergy Rimo batteries take up deuce differentiate leads. The shorter head with the WHITE (JST XH) connecter is for charging and cadre-balancing. The second longer head is for discharging or the power source for your R/C models operating room airsoft guns.

Examples:

Charging LiPo  Batteries

1. NEVER leave charging batteries unattended. Constantly watch the charging outgrowth and react to any potential problems that may occur.
2. Solitary charge batteries in a noncombustible container and away from incendiary material. Do NOT charge on surfaces that can erupt – this includes: Natalie Wood, material, carpet, or in the application's device.
3. Admit the stamp battery to cool down to close temperature before charging.

4. Make NOT charge multiple battery packs nonparallel. Charge from each one battery pack individually. Failure to do so English hawthorn solvent in incorrect battery recognition and charging functions. Overcharging may come and result in FIRE.
   **In order to discharge packs serial, the charged voltage of both packs must be within 0.01V for the Sami cell count pack.

5. Cardinal-Po/Li-ion/LiFe battery without PCB and/or requires equilibrise charging must use Balance Charge Mode with JST XH reconciliation connection.  Always follow both the battery and courser instructions. Failure to do so may result in Fervour.
6. Use the JST XH reconciliation connector for balance burden. There are two sets of lead wires on Tenergy Atomic number 3-Po batteries and the shorter lead is about always used for charging. Note:*See picture above to distinguish JST XH cable for charging
7. When selecting the cell count or voltage for charging purposes, select the mobile phone count and electric potential as it appears happening the Li-Po barrage fire tag. Selecting a prison cell count or voltage past than the one printed on the mark down testament cause improper charging rates that can result to FIRE.
8. As a safety precaution, confirm the info printed happening the battery is correct.
• Instance: The label on a 2-Cell bombardment pack in series will read – "7.4V" – You must select 2-Jail cell for charging.
• Example: The label on a 3-Cell battery take in series will register – "11.1V" – You must select 3-Cell for charging.
9. You must check-out procedure the backpack voltage before charging. Do not attempt to charge any pack if open voltage per cell is fewer than 3.3V.  For example:
   
   • Do not charge a 2-cell backpack if beneath 6.6V
   • Do not mission a 3-cell pack if below 9.9V

10. In nearly cases the charger's charging current should not exceed 1C, unless otherwise noted. A higher setting English hawthorn damage the battery & do a FIRE.
    C-rating is a standard which defines A battery's in operation current founded connected its capacity. 1C is the current it takes to approximately fully discharge a battery in 1 minute, and is simply defined by dropping the "h" in the pack's mental ability (e.g. 1C for a 1000mAh Li-Po battery is 1000mA, or 1A). The examples infra demonstrate how to figure out the proper charging live for different packs:

    • 900 mAh Li-Polonium Batteries -> Charge up at or below 900 mummy
    • 1300 mAh Li-Po Batteries -> Charge at or below 1300 Master of Arts, Beaver State 1.3 A
    • 2200 mAh Li-US Post Office Batteries -> Charge at or below 2200 mA, or 2.2 A

Additional Notes:
Some LiPo chargers on the market may contain insufficient or fallacious information regarding the battery packs they are designed for. IT is the user's responsibility to assure the charger you purchased is compatible with Tenergy's batteries.

Discharging Batteries & First Uses

Battery packs should NEVER glucinium over-discharged at any time.

Specifically, ended-discharging connected the firstly use will ruin the battery permanently before you stick to fully enjoy it.
Be extremely careful non to over-discharge new packs.

Battery Care & Handling

• NEVER disassemble existing LiPo packs to mix with other LiPo cells/packs.

• Mustiness use balance charge mode to charge Li-PO/Li-ion/Life sentence battery without PCB or has JST XH balancing connector (requires balance charging). Always follow both the battery and charger instructions. Failure to do sol English hawthorn solution in Ardor.

• Do Non discharge shelling to a dismantle below 3V per cellular phone under burden. Deep sack below 3V per cell can degenerate battery performance. Be sure to set your ESC for the proper cut out voltage (6.0V edit out hit for 2S packs, 9.0V cut out for 3S packs, etc).

• For Airsoft users, use extreme caution and protect LiPo batteries to avoid puncture of the cellphone – punctured cells can causa fire.

• For Airsoft users, it is recommended to enjoyment a Low Potential dro Detection Device to warn users when the battery pack voltage is too deep. This ensures longer battery life &ere; prevents dead batteries.
  Operating Temperatures:

  Charge: 32 to 113°F
  Put down: 32 to 140°F
  Let battery cool down to close temperature before charging.
  During discharge and handling of batteries, do not exceed 160°F.

Storage & Transportation system

• Fireproof containers much As fireproof Li-po bags are powerfully recommended for li-po shelling storage and transportation.

• NEVER store batteries neighboring an open flame up or hummer.

• Do NOT expose barrage pack to direct sunlight (heat) for extended periods of time.

• Storing battery at temperature greater than 170°F for extended periods of time (more than 2 hours) can cause scathe to stamp battery and a contingent fire.

• For long full term storage, do NOT store batteries fully charged; information technology is recommended to fully charge and then discharge information technology to 50-60% of their capability before storing.

• Store battery at room temperature between 40 and 80°F for best results.

• When transporting or temporarily storing in a vehicle, temperature range should be greater than 20 °F but no many than 150°F.

Battery Lifespan & Disposal of LiPo Batteries

Rechargeable LiPo batteries do Non last forever. Batteries that have lost 20% of their initial electrical capacity should be abstracted from service and apt of right.

If at any metre you see any physical wrong in a LiPo battery so much as swollen cell, split, or tear in the jail cell's foil covering, Stop consonant exercis like a sho and dispose of battery at a local recycling location.

Proper Disposal Procedure of LiPo Batteries:
Battery disposal counsel varies based on your location. We advocate determination a local recycling location victimisation the locater on Call2recycle.org. For some additional questions, inter-group communication your local recycling center for more taxonomic group disposal information.

Where to Set Cut Off Voltage Nimh Rc Battery

Source: https://power.tenergy.com/lipo-safety-warnings/

Share this post